Skip to content
IDAHO
CATTLE GUARDS

Wings

Cattle guard wings: do you need them?

Wings close the gap between the end of the guard and your fence. They stop livestock walking around the crossing and give equipment a sloped surface to meet when it turns in off the road. If the approach is at all angled - a corner, a junction, anywhere a trailer swings wide - you want them.

Plan view: cattle guard, wings, fence tie-in and gateLooking down on a crossing. The guard sits in the road opening, wings flare out to meet the fence on each side, and a gate at least twelve feet long sits in the fence line within thirty-three feet of the highway.WINGSGUARD IN THE OPENINGGATE, 12 FT MINIMUMFENCE TIE-INROAD
On a public road, Idaho Code 40-2310 requires a gate at least 12 ft long in the connected fence, within 33 ft of the highway, kept unlocked.

What the drawing shows

Looking down, the guard sits in the opening and the wings run from each end out to where the fence comes in. The gap they close is the one livestock find first. A cow does not jump a cattle guard - she walks to the end of it and looks for ground.

On a public road the drawing also shows the gate the statute requires in the connected fence: at least 12 ft long, within 33 ft of the highway, unlocked.Idaho Code 40-2310, cited.

Wings pay for themselves when

Angled approach
Equipment turns in off a road rather than arriving square.
Corner or junction
The fence meets the road at anything other than a right angle.
Determined stock
You have animals that test fence lines - and most people do.
Wide equipment
Duals, swathers or implements that overhang the running surface.

How the fence tie-in is done

The tie-in is the part that decides whether the crossing holds stock. The existing fence is brought to the wing and anchored so there is no gap at the bottom and no slack in the wire - which usually means a braced post at the wing rather than tying off to the guard itself. Pulling a fence tight against a steel frame transfers every pull on that fence into the frame, and that is not what the frame is for.

We include wings and the fence tie-in in an install quote as a matter of course, because a crossing that leaks stock is not finished.What an install includes.

Questions we get asked

What do cattle guard wings do?
They flare from each end of the guard out to the fence line, closing the gap a cow would otherwise walk through and giving equipment a sloped surface where it turns in. Without them, the ends of the guard are both an escape route and something to hit.
Do I always need wings?
No. A straight crossing where the fence already meets the guard squarely and nothing turns in sharply can work without them. Corners, junctions, wide approaches and anywhere a trailer swings are where they earn their cost.
Can wings be added later?
Often yes, depending on the product and how the guard was set. It is cheaper to fit them during the original install, because the excavation and the fence tie-in are already open.
Are wings the same as the fence tie-in?
No, though they are done together. The wing is the flared panel at the end of the guard; the tie-in is how your existing fence is brought to it and anchored so there is no gap and no slack wire.
Do wings help with drifting snow or runoff?
They change how water and snow move at the ends of the crossing, which can help or hurt depending on the slope. It is one of the things we look at during the site review rather than something to decide from a catalogue.

Takes a minute, and there is no obligation.

Get my free quote