Skip to content
IDAHO
CATTLE GUARDS

Acreage and rural driveways

Driveway cattle guards

A cattle guard at the end of the lane means you stop getting out of the truck to open a gate. For a rural driveway that usually means a 12 or 14 ft guard, rated for the heaviest thing that actually comes up the lane - and the answer to that is often a delivery truck, not your pickup.

The acreage version of the same job

Mechanically a driveway guard is a ranch guard at a smaller width: a frame with rails, set on a base, over a pit that has to drain. The differences are practical. The crossing is close to the house, so noise and appearance matter more. The lane is often the only access, so the install cannot block it for days. And the vehicles are mixed - your pickup, a propane truck, a gravel delivery, an ambulance you hope never comes.

That last one is why we ask what the heaviest realistic vehicle is rather than what you drive.

Cattle guard cross-sectionSide section through a cattle guard: rails spanning two concrete abutments over an excavated pit, with a gravel cleanout below and the roadway on each side.OPENING WIDTHRAILS + SPACINGABUTMENTGRAVEL CLEANOUT
Cross-section of a concrete-abutment install. Schematic: rail size and spacing come from the manufacturer's spec sheet.

For a driveway crossing

Typical width
12-14 ft, wider if a trailer turns in off a county road.
Load class
Sized for delivery and service trucks, not just the family pickup.
Base
Gravel is common; rock or a high water table may force concrete.
Permission
Usually none for a private drive - but check your county, HOA and easements.
Horses
Use a gate. A standard guard is not for horse traffic.
Measuring the opening for a cattle guardLooking down on a road between two fence lines. The travelled surface is measured first, then the guard is sized wider than it so equipment does not run off the end of the rails.GUARD WIDTHTRAVELLED SURFACESHOULDER EACH SIDEMEASURE THE SURFACE EQUIPMENT USES, NOT THE GAP BETWEEN POSTS
Measure the surface traffic actually uses, at the widest point, then size the guard wider than it. How much wider depends on what turns in - we settle it at the site review.

Where the driveway meets the road

A guard set back on your own lane and a guard at the junction with a public road are two different projects. The second one is in or near someone else's right-of-way, which brings in the county or the highway district - and if the road is a state highway, the Idaho Transportation Department and its encroachment permit process.

Set back on your own property, it is usually a straightforward private install. We will tell you which situation you are in before you spend anything.

Who has to say yes, and when

Questions we get asked

How much is a driveway cattle guard installed?
Width, load class and base type decide most of it, and the ground decides the rest - rock or a high water table changes the excavation. We are setting published ranges from current quotes; ask and we will quote your driveway specifically. What moves the price.
Do I need permission for a cattle guard on my own driveway?
If the crossing is entirely on your property and on a private driveway, you generally do not need road-authority consent - but county, HOA, easement and right-of-way rules can still apply, and where your driveway meets a public road is a different question. Check with your county and highway district. The rules, cited.
Will a cattle guard take a delivery truck or a moving van?
Only if it is rated for it. A guard sized for your pickup is not the design case for a loaded delivery truck or a concrete truck. Tell us the heaviest vehicle that realistically comes up the lane and we will size for that.
Will it hold horses?
Treat a standard cattle guard as unsuitable for horse traffic - a hoof can go through the rails and the injuries are severe. Use a gate for horses unless a manufacturer documents a design specifically for them.
Is it noisy?
Driving across rails makes noise, and a guard close to the house is close to the noise. Most people find it a fair trade for not getting out of the truck twice a day, but it is worth thinking about where the crossing goes.
What about snow plowing?
Tell whoever plows your lane that the guard is there, and where. A plow blade dropped onto the leading edge of a frame does damage in both directions. Marking the ends helps.

Takes a minute, and there is no obligation.

Get my free quote