Skip to content
IDAHO
CATTLE GUARDS

Ranch gates

Ranch gate installation

A sagging gate is almost never the gate - it is the hinge post. That post carries a 16 ft gate as pure leverage, so it goes deeper than you would think, braced against the fence pull as well as the weight. Get the post right and the gate swings true for decades.

Ranch gate elevation with the 12 foot minimumA tubular ranch gate hung between two posts, with a dimension line showing the twelve foot minimum length Idaho Code 40-2310 requires in the fence beside a public-road cattle guard.12 FT MINIMUMUNLOCKED AT ALL TIMES
Beside a cattle guard on a public road, Idaho Code 40-2310 requires a gate at least 12 ft long, within 33 ft of the highway, kept unlocked.
  1. Set the opening and the swing

    Where the gate hangs from, which way it opens, and what has to pass through it. A gate that opens into the only place a trailer can stand is a gate that gets left open.

  2. Dig for the hinge post

    The hinge post carries the whole gate as leverage, so it goes deeper than the latch post and deeper again in loose or sandy ground. This is the hole that decides whether the gate sags.

  3. Set and brace

    Posts set plumb, concreted or tamped to suit the ground, and braced against the pull of the fence as well as the weight of the gate.

  4. Hang and level

    Gate hung, hinges adjusted, and the gate checked for level swing across its full arc - including that it holds position rather than drifting.

  5. Latch and fence tie-in

    A latch that works in gloves and in frost, and the fence tied in so there is no gap at the post. Then it gets opened and closed enough times to prove it.

Why we do gates at all

Because a cattle guard on a public road legally requires one, and because the two jobs share a fence line, a machine and a trip. Fitting the gate while we are there is cheaper for you than a second mobilisation, and it means one person is accountable for the whole crossing rather than two trades pointing at each other.Gate sizes and the statutory requirement.

Questions we get asked

How deep should a gate post go?
Deep enough for the gate it carries and the ground it is in, which is why there is no single number worth printing. A hinge post for a 16 ft gate in loose ground needs considerably more than a line post. We set them to carry the gate without leaning, and that is the standard we work to.
Does a gate post need concrete?
Often, and not always. Good tight ground, well tamped, can hold a post for decades; sand, gravel or a high water table usually call for concrete. The real failure mode is a post that was never braced against the fence pull, concrete or not.
Can you re-hang an existing gate?
Yes, and on a cattle guard job it is common - the gate is fine and the post has given up. If the gate itself is twisted beyond adjustment we will say so rather than hang it and hope.
How long does it take?
A gate hung alongside a cattle guard install adds hours rather than days. Standalone, it is usually a half-day job once we are on site, plus cure time if the posts are concreted.
What about a gate on a public road crossing?
That gate has legal requirements: at least 12 ft long, within 33 ft of the highway, unlocked at all times. We fit it to meet them. Confirm the specifics for your road with your county or highway district.

Takes a minute, and there is no obligation.

Get my free quote